Use and Care Manual

ManualsBrandsYARD FORCE ManualsLawn Mowers28-Volt 7 in. Robot Lawn Mower, Brushless Wheel Motors, CloudHawk App and Wifi Control, 1/3 Acre

20 21

Hotline: 1-866-902-9690 Hotline: 1-866-902-9690

OPERATION

Control panel

Initial interface

when power on your robotic mower, after entering the defult PIN 0000, you will see the initial interface on

the display.

Enter PIN Code

* ** *

Current signal status Robotic mower working time

Battery pack

remaining capicity

Current mower status

*Robotic mower

working date

S1 02:50-13:50 03:50-15:00 68%

Standby

Sun

SatFriThuWedTueMon

*NOTE: Inverted color means date was selected.

Mon

Before starting your robotic mower

Please follow below steps to adjust the time setting before starting your robotic mower.

1. Press the

button to enter the menu setting.

Timer Sensor PIN English

2. Press the button to enter time setting.

System date

System time

1 2

3. Press the button to set the system date

2021-01-29

Set system date

4. Press the button to set the system time

13:57

Set system time

5. Press the button to enter next page

Working date

Working time

1 2

6. Press the button to set the working date

- Press the relative numbers to select the working date your required.

Set working day

Sun

SatFriThuWedTueMon

1 2

7. Press the button to set the working time

- Press the relative numbers to select the working time your required.

Set working time

Sun

SatFriThuWedTueMon

02:50-13:50 03:50-15:00

1 2

NOTE: If the working day is activated, then the blinking cursor will move to specied time setting.

OPERATION

Summary of content (4 pages)

PAGE 1
OPERATION OPERATION Before starting your robotic mower Control panel Please follow below steps to adjust the time setting before starting your robotic mower. button to enter the menu setting. 1. Press the Timer 1 Sensor 2 2. Press the Initial interface PIN 3 English 4 button to enter time setting. System date System time 1 2 3 when power on your robotic mower, after entering the defult PIN 0000, you will see the initial interface on the display. 3.
PAGE 2
OPERATION OPERATION Sensor setting 1. Press the - After re- enter the new PIN, press button to enter the menu setting. Timer 1 Sensor 2 PIN 3 button complete this setting. Language 1. Press the button to enter the menu setting. 2. Select related number to set the language you require. English 4 Current Language Setting 2. Press the button to enter the sensor setting.
PAGE 3
OPERATION MAINTENANCE AND STORAGE Cutting height adjustment The cutting height can be adjusted by rotating the height adjustment dial located on the top of the machine. Cutting height range from 1-1/3"-3". Maintenance work that has not been described in these instructions must be carried out by a servicing agency authorised by the manufacturer. Only use original parts. NOTE! We recommend using an ordinary lawn mower or trimmer to cut the lawn below 2.5 in before using the Robotic Mower.
PAGE 4
MAINTENANCE AND STORAGE MAINTENANCE AND STORAGE 1. Ensure the main power switch is turned OFF. Clean the underside as instructed. 2. Set the Autonomous Mower to the lowest cutting height. 3. Turn the mower upside-down. Remove the 5 screws fixing the battery compartment's lid. Note one screw is partially covered by the blade protector and is only accessible through a service hole. 4. Pull out the battery and disconnect it from the Autonomous Mower. 5.