Service manual
3 - 32
CHK
ADJ
ADJUSTING THE EXUP CABLES
EB303210
ADJUSTING THE EXUP CABLES
1.Remove:
• fuel tank
• bottom cowling
Refer to “FUEL TANK” and “COWL-
INGS”.
2.Remove:
• EXUP valve pulley cover 1
3.Check:
• EXUP system operation
▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼ ▼
a. Disconnect the EXUP servomotor
coupler 1.
b. Connect the battery to the EXUP ser-
vomotor coupler and check if the ser-
vomotor operates properly.
ACHTUNG:
CAUTION:
To avoid damaging the servomotor, do
not leave the battery connected to it for
more than a few seconds.
c. Check that the EXUP valve operates
properly.
d. Connect the EXUP servomotor cou-
pler.
▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲ ▲
Battery positive lead → black/yellow 2
Battery negative lead → black/red 3
4.Measure:
• EXUP cable free play a
Max. EXUP cable free play
(at the EXUP valve pulley)
1.5 mm