User Guide

2 - 21
SPEC
CABLE ROUTING DIAGRAM
EC240000
CABLE ROUTING DIAGRAM
1 Fuel tank breather hose
2 Hot starter cable
3 Radiator hose 4
4 Cylinder head breather hose
5 Radiator hose 1
6 Oil tank breather hose
7 Hose guide
8 Brake hose
9 “ENGINE STOP” button lead
0 Clamp
A Sub wire harness
B TPS (throttle position sen-
sor) lead
C Neutral switch lead
D Oil hose
E Radiator breather hose
F CDI magneto lead
G Carburetor breather hose
H Overflow hose
Å Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
ı Pass the hot starter cable
between the cylinder head
breather hose, oil tank breather
hose and ignition coil, then on
the outside of the left engine
bracket.
Ç Pass the cylinder head breather
hose on the outside of the radia-
tor hose 1 and on the inside of the
radiator pipe (radiator hose 4).
Î Fit the brake hose into the
guides on the protector.
‰ Fasten the “ENGINE STOP”
button lead and sub wire har-
ness to the frame with a plastic
locking tie and cut off the tie
end.
Ï Fasten the sub wire harness
and hot starter cable to the
frame at the white tape for the
sub wire harness with a plastic
locking tie and cut off the tie
end.
Ì Fasten the sub wire harness to
the frame with a plastic locking
tie and cut off the tie end.
C
9
0
A
0
0
0
0
0
B
C
D
0
0
E
0
F
0
1
2
8
7
6
5
4
3
G
H
G
9
A
D
E
C
B
A
A
C
B
B
Ç
Î
Å
ı
Ø
˜
ˆ
Ò

Ô
È
Ì
Ó
Ì
Ï
‰
‰
∏
*
*