manual

74 En
ADJUSTING SYSTEM PARAMETERS
You can set the initial volume level when the power of this
unit is turned on.
1 Repeat steps 1 to 3 in “Using the system
parameters” on page 72.
2 Set the operation mode selector to YSP to
switch to the operation mode of this unit.
3 Press / on the remote control so that
TURN ON VOLUME is shown in the front
panel display.
4 Press ENTER.
5 Press / to adjust the initial volume level.
Control range: MAX, 99 to 01, OFF
Control step: 1
6 Press STANDBY/ON on the front panel to set
this unit to the standby mode.
The new setting for the maximum volume level will
be activated when you turn on the power of this unit
next time.
You can test the beam output from this unit to experience
the sound beam.
y
You can also perform this function simply by pressing INPUT on
the front panel. A sound beam is output from this unit when you
press and hold INPUT for more than 2 seconds. The sound beam
shuttles between left and right twice, and then stops.
1 Repeat steps 1 to 3 in “Using the system
parameters” on page 72.
2 Set the operation mode selector to YSP to
switch to the operation mode of this unit.
3 Press / on the remote control so that
DEMO MODE is shown in the front panel
display.
Setting the TURN ON VOLUME
YSP
TV/AV
ENTER
VOL
TURN ON VOLUME
ENTER
ENTER
Setting the DEMO MODE
STANDBY/ON
YSP
TV/AV
ENTER
VOL
DEMO MODE