Operation Manual

60 En
MANUAL SETUP
■ DD/DTS Dynamic Range
(Dynamic range of Dolby Digital and
DTS signals)
Use to select the amount of dynamic range compression.
This setting is effective only when the unit is decoding
Dolby Digital and DTS signals. Dynamic range is the
difference between the smallest sound that can be heard
above the noise of the equipment and the biggest sound
that can be heard without distortion.
Choices: MIN (minimum), STD (standard),
MAX (maximum)
Select to adjust the dynamic range compression.
• Select MIN for listening to sources at low volume
levels.
• Select STD for general use.
• Select MAX for feature films.
Use to manually adjust the various parameters related to
the audio and video input.
SET MENU → MANUAL SETUP → INPUT MENU
■ INPUT MODE (Input mode)
Use to designate the input mode for the input sources
connected to the DIGITAL INPUT jacks when you turn on
the power of this unit. For information on the types of
audio signals that can be output by this unit, see “Selecting
the input mode” on page 68.
Choices: AUTO, LAST
• Select AUTO to set this unit to automatically detect the
type of input signals and select the appropriate input
mode.
• Select LAST to set this unit to automatically select the
last input mode used for that input source. If the type of
input signals is different from the setting, no sounds
will be produced.
MIN STD MAX
[ ]/[ ]:Select
[ENTER]:Return
p
p
E)DD/DTS Dynamic Range
p
INPUT MENU
A)INPUT MODE
B)INPUT TRIM
C)INPUT RENAME
D)HDMI SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
3)INPUT MENU
.
p
p
AUTO LAST
[ ]/[ ]:Select
[ENTER]:Return
p
p
A)INPUT MODE
p