Owner's Manual

En 60
SETUP
Setting sound field program parameters
CINEMA DSP parameters
Selects a surround decoder to be used with a sound field program
in the MOVIE category. J1
Change the effect level (level of the sound field effect to be added).
You can adjust the level of the sound field effect while checking the
sound effect.
Parameters usable in certain sound field
programs
2ch Stereo only
Automatically bypasses the DSP circuit and tone control circuit
depending on the condition of tone control etc., when an analog
sound source is played back. You can enjoy a higher quality sound.
7ch Stereo only
Adjusts the center channel volume. J2
Adjusts the volume of the surround L channel. J2
Adjusts the volume of the surround R channel. J2
Adjusts the volume of the surround back channel. J2
Straight Enhancer/7ch Enhancer only
Adjusts the effect level of the compressed music enhancer mode.
<Dolby PLIIx Movie>
<Neo:6 Cinema>
Dolby PLIIx Movie
(Dolby PLII Movie)
Selects the Dolby Pro Logic IIx Movie (or
Dolby Pro Logic II Movie) decoder.
Neo:6 Cinema Selects the Neo:6 (Cinema) decoder.
DSP Level
Adjustable range -6 dB to 0 dB to +3 dB
Default setting 0 dB
Adjust “DSP Level” as follows:
• The effect sound is too soft.
• There are no differences between effects of the sound field
programs.
→ Increase the effect level.
• The sound is dull.
• The sound field effect is added too much.
→ Reduce the effect level.
Direct
Auto (Default) Outputs sound by bypassing the DSP circuit and tone
control circuit when both tone controls of “Bass” and
“Treble” are set to 0dB.
Off Does not bypass the DSP circuit and tone control
circuit.
CT Level
Adjustable range 0 to 100%
Default setting 100%
SL Level
Adjustable range 0 to 100%
Default setting 100%
SR Level
Adjustable range 0 to 100%
Default setting 100%
SB Level
Adjustable range 0 to 100%
Default setting 35% (7.1-channel configuration)
50% (6.1-channel configuration)
EFCT LVL
High (Default) Standard effect.
Low Sets when the high-frequency signals of the source are
emphasized excessively.
J
1 : Surround decoders cannot be changed when used with the following MOVIE
sound field programs.
• Mono Movie
• Sports
• Action Game
• Roleplaying Game
J
2 : Not displayed when speakers are set to be inactive.