Owner's Manual

En 50
SETUP
Setting various functions (Setup menu)
Front
Selects the size (sound reproduction capacity) of the front
speakers. J1
Center
Selects the size of the center speakers.
Sur. LR
Selects the size of the surround speakers.
Sur. B
Selects the size of the surround back speakers.
Crossover
Sets the lower limit of low-frequency component output from
speakers set to “Small.”
Audio with a frequency below that limit will be produced from the
subwoofer or the front speakers. J3
SWFR Phase
Sets the phase of the subwoofer if the bass audio is lacking or
unclear.
Extra Bass
Allows the front channel low-frequency components to be
produced exclusively by the subwoofer, or by both the subwoofer
and the front speakers.
Small (Default) Select this for small speakers. The subwoofer will
produce front channel low-frequency
components. J2
Large Select this for large speakers. The front speakers will
produce all of the front channel frequency
components.
None Select this when there is no center speaker. The front
speakers will produce center channel audio.
Small (Default) Select this when a small center speaker is connected.
Large Select this when a large center speaker is connected.
None Select this when no surround speakers are connected.
The front speakers will produce surround channel
audio signals.
Small (Default) Select this when the surround speakers are small.
Large Select this when the surround speakers are large.
• When set to “None,” no sound is produced from the surround
back speaker even if that speaker is connected.
• When set to “None,” the sound field programs will change to
Virtual CINEMA DSP mode.
None (Default) Select this when no surround back speakers are
connected.
SMLx1 Select when one small surround back speaker is
connected.
SMLx2 Select when two small surround back speakers are
connected.
LRGx1 Select when one large surround back speaker is
connected.
LRGx2 Select when two large surround back speakers are
connected.
• When there are no surround speakers are inactive, the setting will
automatically change to “None.”
• You can set surround back audio signals, including from the
playback source, to be mixed down and produced from a single
speaker (6.1-channel layout) or produced from left and right
surround back speakers (5.1-channel layout).
40Hz 110Hz
60Hz 120Hz
80Hz (Default) 160Hz
90Hz 200Hz
100Hz
NRM (Default) Does not change the subwoofer phase.
REV Reverses the subwoofer phase.
ON The subwoofer and the front speakers produce the
front channel low-frequency components.
OFF (Default) Depending on the size of the front speakers, either the
front speakers or the subwoofer produce the front
channel low-frequency components.
When the “Subwoofer” is set to “None,” the “Extra Bass”
setting is disabled.
J
1 : When “Subwoofer” is set to “None,” you can only choose “Large.” If the front
speaker setting is “Small” and you change “Subwoofer” to “None,” it will
automatically change to “Large.”
J
2 : You can set the low-frequency components of audio signals transmitted from
the front speakers to the subwoofer by using “Crossover” setting.
J
3 : If your subwoofer has a volume control or a crossover frequency control, set
the crossover frequency to maximum and the volume to half (or slightly less).