Owner`s manual

20 En

USEFUL OPERATION

■ Setup menu list

If the “SP TYPE” is set to the default setting (“BAR”), “SP DISTANCE” will not be displayed.

You can change various settings of this system using

the setup menu.

1 Press SETUP to enter the setup menu.

“SW LEVEL” is displayed in the front panel

display.

2 Press the cursor / to select menu

and press (Center).

The current setting is displayed.

3 Press the cursor / to adjust the

value of each menu.

Press and hold the cursor / to change the

setting value faster.

4 Press SETUP again to exit the setup

menu.

Press RETURN to return to the previous menu.

If you do not operate within 30 seconds after entering the

setup menu, the system automatically exits the setup menu.

Setup menu

Overview

Item Description of function Page

1: SW LEVEL

Adjusting the volume balance during playback ☞ P. 212: CENTER LEVEL

3: SUR. LEVEL

4: TONE BASS

Adjusting high/low frequency sound (tone control) ☞ P. 21

5: TONE TREBLE

6: AUDIO DELAY Adjusting the audio delay ☞ P. 21

7: HDMI AUDIO Setting the audio output ☞ P. 21

8: HDMI CONTROL Switching on/off the HDMI control function ☞ P. 21

9: DISPLAY MODE Changing the brightness of the front panel display ☞ P. 22

10: SP TYPE Changing the setting of the speaker type ☞ P. 22

11: SP DISTANCE Setting the distance between the speakers ☞ P. 22

Note

Basic procedure

1, 4

2, 3

Note