Service manual

– 26 –
ENG
MIDDLE GEAR
REMOVING THE MIDDLE DRIVEN SHAFT
1.Remove:
●
Nut 1
●
Washer
●
Front drive shaft coupling
N
OTE:
Use the coupling gear holding tool 2 to hold
the front drive shaft coupling.
2.Remove:
●
Nut 1
●
Washer
●
Coupling gear 2
N
OTE:
Use the coupling gear/middle shaft tool 3 to
hold the coupling gear.
Coupling gear holding tool:
P/N. YM-01486, 90890-01486
Coupling gear/middle shaft tool
P/N. YM-01230, 90890-01229
1
2
3.Remove:
●
Bearing housing assembly 1
*****************************************************
Removal steps:
●
Clean the outside of the middle driven shaft.
●
Place the middle driven shaft onto a hydrau-
lic press.
CAUTION:
●
Never directly press the shaft end with a
hydraulic press, this will result in damage
to the shaft thread.
●
Install the suitable socket
2
on the shaft
end to protect the thread from damage.
●
Press the shaft end and remove the bearing
housing.
*****************************************************