Operation Manual

ENGLISH
YDP-S31 Owner’s Manual
35
3 Mount A.
CAUTION
• Be careful not to pinch your fingers or drop the
unit.
• Do not hold the keyboard in any position other
than the position instructed in this document.
4 Secure A.
4-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
4-2 Secure A by tightening four short screws (6
x 20 mm) from the bottom.
5 Connect the pedal cord.
5-1 Untie the bundled pedal cord, then insert
the plug to the [TO PEDAL] jack from the
rear.
5-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
5-3 Remove the screws from both ends of B,
then attach the anti-fall brackets using the
screws.
CAUTION
• If there is no wall immediately behind the instru-
ment, be sure to install anti-fall brackets on the
instrument.
6 Connect the AC adaptor.
6-1 Insert the AC adaptor plug into the [DC IN
12V] jack from the rear.
6-2 Attach the cord holder on the right (or left)
end (whichever is closer to an AC outlet) of
the rear panel, then clip the power cord into
the holder.
A
Be sure to place your hands at least 10 cm
from either end of A when positioning it.
Align the screw holes.
2
1
A
A
The two anti-fall brackets are identical.
(Either one can be used for left or right.)
B
1
3
2
1
2
33