Electronic Keyboard User's Manual

ENGLISH
YDP-S30 Owner’s Manual
34
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
•To disassemble, reverse the assembly sequence given below.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
1 Attach B to C and D.
1-1 Align C and D with each end of B.
1-2 Attach C and D to B by tightening the long
screws (6 x 30 mm) securely.
2 Mount A.
CAUTION
• Be careful not to pinch your fingers or drop the
unit.
• Do not hold the keyboard in any position other
than the position instructed in this document.
Have a Phillips-head (+) screwdriver ready
A
CDE
F
B
AC Power Adaptor* x 1
6 x 30mm long screws x 4
6 x 20mm short screws x 4
5 x 20mm thin screws x 4
Cord holders x 5
Back toe x 2
* The adaptor may not be included, or may look different from the illustration above,
depending on your particular area. Please check with your Yamaha dealer.
1
2
D
C
B
A
Be sure to place your hands at least 10 cm
from either end of A when positioning it.
Align the screw holes.
32