Owner`s manual

YDP-161/141 Owner’s Manual
YDP-161/141
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)
YDP-161
(2 wires)
• This applies only to products distributed by Yamaha-
Kemble Music (U.K.) Ltd.
YDP-141
(standby)
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modifications not expressly approved
by Yamaha may void your authority, granted by the
FCC, to use the product.
2. IMPORTANT: When connecting this product to
accessories and/or another product use only high
quality shielded cables. Cable/s supplied with this
product MUST be used. Follow all installation
instructions. Failure to follow instructions could void
your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to
comply with the requirements listed in FCC
Regulations, Part 15 for Class “B” digital devices.
Compliance with these requirements provides a
reasonable level of assurance that your use of this
product in a residential environment will not result in
harmful interference with other electronic devices.
This equipment generates/uses radio frequencies
and, if not installed and used according to the
instructions found in the users manual, may cause
interference harmful to the operation of
other electronic devices. Compliance with FCC regu-
lations does not guarantee that interference will not
occur in all installations. If this product is found to be
the source of interference, which can be determined
by turning the unit “OFF” and “ON”, please try to elim-
inate the problem by using one of the following mea-
sures:
Relocate either this product or the device that is being
affected by the interference.
Utilize power outlets that are on different branch (cir-
cuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reori-
ent the antenna. If the antenna lead-in is 300 ohm rib-
bon lead, change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfac-
tory results, please contact the local retailer autho-
rized to distribute this type of product. If you can not
locate the appropriate retailer, please contact Yamaha
Corporation of America, Electronic Service Division,
6600 Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to those products
distributed by Yamaha Corporation of America or its
subsidiaries.
IMPORTANT NOTICE FOR THE UNITED KINGDOM
Connecting the Plug and Cord
IMPORTANT. The wires in this mains lead are coloured in
accordance with the following code:
BLUE :NEUTRAL
BROWN :LIVE
As the colors of the wires in the mains lead of this
apparatus may not correspond with the colored makings
identifying the terminals in your plug proceed as follows:
The wire which is colored BLUE must be connected to
the terminal which is marked with the letter N or colored
BLACK.
The wire which is colored BROWN must be connected
to the terminal which is marked with the letter L or
colored RED.
Making sure that neither core is connected to the earth
terminal of the three pin plug.
OBSERVERA!
Apparaten kopplas inte ur växelströmskällan (nätet) så
länge som den ar ansluten till vägguttaget, även om
själva apparaten har stängts av.
ADVARSEL: Netspændingen til dette apparat er IKKE
afbrudt, sålænge netledningen sidder i en stikkontakt,
som er tændt — også selvom der er slukket på
apparatets afbryder.
VAROITUS:
Laitteen toisiopiiriin kytketty käyttökytkin ei
irroita koko laitetta verkosta.
108
YDP-161_Es_m_om_a0.book Page 42 Monday, March 22, 2010 2:45 PM