Owner’s Manual

PREPARATION ➤ Installation En 8
Installation
The unit can be installed on a TV stand or mounted on a wall (p.9).
It is equipped with remote control sensors positioned to support installation on a TV stand or mounting on a wall.
Installing the unit on a TV stand, etc.
Position the unit so that the keys are on the far side of the unit.
About the TV remote repeater
The unit receives signals from the TV’s remote control via the remote control sensor
located on the front panel. It then transmits these signals from the TV remote repeater
located on the rear panel.
HINT
• This function is available only when the TV’s remote control uses infrared signals.
• The TV’s remote control can be used even when the unit is turned off as long as the unit’s power cable is
plugged into an AC wall outlet.
Cautions
• Do not stack the unit and a BD player or other device directly on each other. Doing so may cause a
malfunction due to vibrations.
• Do not hold the speaker portion (fabric parts) on the front and the top of the unit.
• The unit contains non-magnetic shielding speakers. Do not place magnetically sensitive items (hard
disk drive, etc.) near the unit.
• Depending on your installation environment, it may be better to connect the unit and external devices
before installing the unit.
Remote control sensor (front panel)
Keys
Caution
Position the unit more than 5 cm (2 in) away from the TV to ensure proper transmission of signals from
the remote control to the remote control sensor on the TV.
TV remote repeater
TV’s remote control
More than 5 cm (2 in)
TV remote control sensor