User Guide

Pairing Aux Sends 101

01V—Owner’s Manual

Pairing Aux Sends

Aux sends 1 and 2 and aux sends 3 and 4 can be paired together for stereo signal pro-

cessing. When paired, the EQ, dynamics, master faders, ON buttons, and monitors of

each aux send are set the same and linked for simultaneous control. In addition to the

linking of aux send master parameters, pairing also affects input channels 1 through 24

and the effects returns. For these channels, aux send controls and pre/post switches are

linked, and aux send panpots appear.

Making Aux Send Pairs

1. Use the [SETUP] button to locate SETUP page 4, as shown below.

2. Use the cursor buttons to select aux pair 1/2 or 3/4, and then press the

[ENTER] button.

The following dialog box appears.

AUX 1 –> 2—Copy the settings of aux send 1 to aux send 2.

AUX 2 –> 1—Copy the settings of aux send 2 to aux send 1.

RESET BOTH—Reset both aux sends to their initial settings.

3. Use the cursor buttons to select a pairing mode, and then press the

[ENTER] button.

The highlighted switch and STEREO label show that the aux sends

are now conﬁgured as a stereo pair.

Releasing Aux Send Pairs

1. On SETUP page 4, use the cursor buttons to select the paired aux switch,

and then press the [ENTER] button.

The following dialog box appears.

2. Select OK, and then press the [ENTER] button.

The stereo pair is broken, and both aux sends operate independently.