Operation Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

6-8

3. Remove the engine oil filler cap

and drain bolt to drain the oil from

the crankcase.

NOTE:

Skip steps 4–6 if the oil filter element is

not being replaced.

4. Remove the oil filter element cover

by removing the bolts.

5. Remove and replace the oil filter

element and O-ring.

6. Install the oil filter element cover

by installing the bolts and tighten-

ing them to the specified torque.

1. Engine oil drain bolt 1. Oil filter element cover

2. Bolt (× 3)

1. O-ring

2. Oil filter element

Tightening torque:

Oil filter element cover bolt:

10 Nm (1.0 m·kg)

E_3bt.book Page 8 Thursday, September 7, 2000 10:01 AM