User Manual
Table Of Contents
- 0. Revision History
- 1. Setup
- 2. Command List
- 3. Command Specifications
- 4. Command Sequence
- 5. Meter Value
- 6. Parameter Value Details
- 6.1. Fader parameter
- 6.2. Other parameters (MTX3, MTX5-D)
- 6.3. Other parameters (MRX7-D)
- 7. Parameter List
- 8. Meter List
MTX3/MTX5-D/MRX7-D/XMV Series/EXi8/EXo8 Remote Control Protocol Speciîš¿cations V3.1.0 rev10
8
1. Setup
1.1. Connection Procedure
Connection when using the NETWORK connector to perform remote control using this protocol
MTX3
Remote Controller
Network
Switch
Ethernet Ethernet
MTX5-D
Remote Controller
Network
Switch
Ethernet Ethernet
MRX7-D
Remote Controller
Network
Switch
Ethernet Ethernet
* Also for XMV, EXi8 and EXo8.
XMV can be controlled with the protocol in this document without MTX3, MTX5-D or MRX7-D.
Connection when using the REMOTE connector to perform remote control using this protocol
MTX3
Remote Controller
RS-232C (Crossover cable)
MTX5-D
Remote Controller
RS-232C (Crossover cable)
MRX7-D
Remote Controller
RS-232C (Cross cable)
* XMV, EXi8 and EXo8 do not have REMOTE connectors