Owner`s manual

PERIODIC MAINTENANCE AND MINOR REPAIR
6-29
6
EAU01758*
Front wheel installation
1. Install the speedometer gear unit
housing into the wheel hub. Make
sure the wheel hub and the speed-
ometer gear unit housing are in-
stalled with the projections
meshed into the slots.
2. Lift up the wheel between the front
fork legs. Make sure the slot in the
speedometer gear unit housing fits
over the stopper on the front fork
outer tube.
3. Install the wheel axle and let the
motorcycle down.
4. Install the calipers, caliper bolts
and brake hose holders. Make
sure there is enough gap between
the brake pads before installing
the calipers onto the brake discs.
5. Tighten the wheel axle, pinch bolt
and caliper bolts to the specified
torques.
6. Install the speedometer cable.
7. Push down hard on the handle-
bars several times to check for
proper fork operation.
Tightening torque:
Wheel axle:
73 Nm (7.3 m·kg)
Pinch bolt:
19 Nm (1.9 m·kg)
Caliper bolt:
40 Nm (4.0 m·kg)