Service manual

ENGINE REMOVAL//ENGINE DISASSEMBLY I ENG _J
2. Remove:
oOil level switch lead (_
From the lead guide
oAir shroud 3 (_
ENGINE DISASSEMBLY
CYLINDER HEAD COVER AND CYLINDER
HEAD
1. Align the "T" mark (_ on the flywheel
magneto (_ with the stationary pointer _)
on the crankcasesothat the pistonisat TDC
on the compression stroke.
2. Remove:
oBolts (Cylinder head cover)
oCylinder head cover
NOTE:
Follow numerical ordershown in photo. Start by
looseningeach bolt 1/2 turn until all are loose.
3. Remove:
ePush rods (_
oDowel pins (_)
oNozzle (_) with O-ring _)
J
4. Remove:
....... oSocket bolt (Cylinder head) (_)
oBolts (Cylinder head) (_)
oStay (Air shroud) (_)
NOTE:
Loosen the bolts in stage, using a crisscross
.... pattern.
i
(_ With washer
3-6