User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Checking the version number
- ■ Preparing for the update
- ■ Update procedure sequence
- ■ Decompressing the downloaded file
- ■ Install the MTX-MRX Editor
- ■ Install the Dante Firmware Update Manager (for Dante)
- ■ Computer TCP/IP setting (for Dante)
- ■ Updating the Dante firmware
- ■ Computer TCP/IP setting ( for device main)
- ■ Updating the device main firmware
- ■ About Failsafe Mode
14
10. Check the detected device.
11. Click [Start].
A pop-up is displayed confirming that you wish to proceed.
12. Click [OK] to start the recovery.
Firmware Update Manager will display "Processing Safe Recovery", and then "Safe recovery Done" when the
device(s) are recovered.
13. Exit the Dante Firmware Update Manager, and wait for two minutes before turning off the power to
the device.
14. The correct Dante firmware now needs to be loaded.
Follow steps 2 through 11 described in "
Updating the Dante firmware."
Now recovery and firmware update are completed.
Manual Development Group
© 2014 Yamaha Corporation
Published 02/2017 YJ-C0