User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Checking the version number
- ■ Preparing for the update
- ■ Update procedure sequence
- ■ Decompressing the downloaded file
- ■ Install the MTX-MRX Editor
- ■ Install the Dante Firmware Update Manager (for Dante)
- ■ Computer TCP/IP setting (for Dante)
- ■ Updating the Dante firmware
- ■ Computer TCP/IP setting ( for device main)
- ■ Updating the device main firmware
- ■ About Failsafe Mode
12
9. If "Requires Initialization" appears in the Status field, initialize the specified device.
To start initialization, set DIP switch 7 to the down position and DIP switch 8 to the up position (on the XMV,
Device setup DIP switches 7 and 8), then restart the device. For more information, refer to the User's Manual for
the corresponding device.
When initializing Dante devices (MTX5-D, MRX7-D and Dante model of XMV), ensure that all other Dante
devices on the network are disconnected or powered off. Otherwise initialization could take longer than necessary.
The firmware update is now complete.