User Guide

User support service is available if your user registration is completed.
Registered users can receive the following services:
• Driver software update
• Useful information
• Technical support
For details on the technical support service, see Yamaha’s WAVEFORCE web site
(http://www.waveforce.com).
Installation of the card must be done in the following procedure:
n Notice that installation of the card requires an empty PCI card slot in your computer. If you use a PCI slot that has been occupied
with another card, first remove the driver software for that card, turn off the computer to remove the card, and then reboot the
computer to forcibly recognize that the old card is not there. After completion of this process, turn off the computer and start the
following installation process for the new card.
1 Referring to the manual that came with your computer, as explained in “Consulting on Documentation” of
the paper document (Getting Started) in the package, prepare for installation of the card inside your
computer.
2 Open the antistatic bag and take out the card while holding it by its edge to avoid touching metal PCI
connectors and electronic components on the card.
3 Locate a sticker put on the card that is printed with a card’s serial number. Make a note of the number
for online registration, as explained in “User Registration” above.
4 Make sure the location of internal connectors on the card that attach with appropriate connectors from the
internal devices of the computer (audio lines from CD-ROM drive, Modem card, video card). Each
location of the card’s connector is as follows:
TAD
CDAUDIO (CD In)
VIDEO
CDAUDIO
AUX
PCPCI
TAD (Telephone Answering Device (TAD) In/Out)
VIDEO (Video In)
AUX (AUX In)
Game Port & MIDI
Line In
Mono Microphone In
Line Out
Speaker Out
PCPCI (PC/PCI)
External connectors Internal connectors
Installation of the SoundCard
User Support Service
3
WF192e.qx 5/21/98 9:16 PM Page 3