Owner`s manual

Instruments and indicators
32
indicators, see page 50.
NOTICE
ECM00030
Do not operate the engine without oil. Se-
rious engine damage will occur.
EMU26611
Analog trim meter
This gauge shows the trim angle of your out-
board motor.
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU31642
Command link multifunction
meters
Command link multifunction meters have 6
kinds of meter units; tachometer unit (square
or round types), speedometer unit (square
type), speed & fuel meter unit (square or
round types), and fuel management meter
(square type). The indicator system is slight-
ly different between the round and square
types. Check the model and type of your unit
carefully. This manual describes mainly the
alert indicators. For more details on setting
meters or changing indicator systems, see
the attached operation manual.
EMU36103
Command link multifunction
tachometers
The tachometer shows the engine revolu-
tions per minute. It has functions of trim
meter, adjusting trolling speed, cooling wa-
ter/engine temperature display, battery volt-
age display, total hour/trip hour display, oil
pressure display, water detection alert, en-
gine trouble alert, and periodic maintenance
notification. If the cooling water pressure
sensor is installed, the unit can also show the
cooling water pressure display. However,
even if the cooling water pressure sensor is
not installed, the cooling water pressure dis-
play can be shown by connecting an optional
sensor to the unit. For the optional sensor,
consult your Yamaha dealer. The tachome-
ter unit is available in round or square types.
Check your tachometer unit type.
1. Oil level indicators
ZMU04580
1
ZMU04581
1. Set button
2
1
ZMU05415