Owner`s manual

E
4-6
EMU01568
Lubrication
1) Remove the spark plug(s). Spray
“Yamaha Stor-Rite Engine Fogging Oil”
into each cylinder for 5 seconds.
Grease the spark plug threads and
reinstall the spark plug(s) and torque to
proper specification. (Refer to the sec-
tion “CLEANING AND ADJUSTING
SPARK PLUG” for details).
2) Turn the engine over with the stop lan-
yard disconnected to work the fogging
oil into the piston rings.
3) Fill the oil tanks. This prevents the for-
mation of condensation. For models
with a remote tank, it may be necessary
to manually override the control unit to
completely fill the engine main tank.
(Refer to the section “FILLING OIL” for
details).
4) Change the gear-case oil. (Refer to the
section “CHANGING GEAR OIL” for
details). Inspect the oil for the presence
of water which indicates a leaky seal.
Seal replacement should be performed
by an authorized Yamaha dealership
prior to use.
5) Grease all grease fittings. (Refer to the
section “GREASING” for details).
EMU01904
Cleaning and Anti-corrosion Measure
1) Wash down the exterior of the outboard
with fresh water and dry off completely.
2) Spray the engine’s exterior with
“Yamaha Silicone Protectant” (Part No.
LUB-SILCNE-13-00).
cC
Do not spray when the engine is run-
ning. Also, do not spray near the silencer
or into the engine.
3) Wax the cowling with a non-abrasive
wax such as “Yamaha Silicone Wax”
(Part No. ACC-11000-15-02).
60V-9-13-4 7/28/03 5:37 PM Page 7