User Manual

10.12. "Device Information" dialog box
To open this dialog box, click [Device Information] from the [System] menu on the menu bar.
This lists information for the devices on the network, allowing you to update their firmware or restart them.
•
Network Interface
Shows the name/IP address/subnet mask of the network card currently selected in the "Network Setup"
dialog box.
•
[Refresh] button
Searches again for devices on the network.
This cannot be clicked while an update is in progress.
•
[Detail>>] button
Switch this button on to display to the right the information specific to the device that is currently selected
on the device list.
• Device list
◦ Identify button
When you press this button located at the left of the Unit ID, the indicators of the corresponding
device will flash for several seconds.
◦ Unit ID / Model / Device Name
These columns indicate the device Unit ID, device model name, and device name. If there is a UNIT
ID conflict, an indication is shown.
To change the device name, use the [Device Name] field in the “Properties” area of the “Project”
sheet.

If different types of devices are used, the same Unit ID can be used for them.
However, if the MTX series unit is set to Unit ID mode, the IP address will be
automatically set to 192.168.0.<Unit ID>.
In this case, you must set unique Unit IDs so that they will not overlap (conflict)
among all devices.
10. Dialog boxes
ProVisionaire Design User Guide | 77