User Manual

•
[Enable Inactive Mode] check box
If the check box is selected, the unit automatically enters inactive mode after a time duration specified in
[Waiting Time].
[Inactive LED Brightness] specifies the brightness of the LEDs when inactive.
If the check box is cleared, the drop-down menu is grayed-out and you will be unable to set the brightness.
•
[Panel Lock] check box
If this check box is selected, the DCP panel will be locked when the preset library is recalled.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding down DCP switch 1 for
two seconds will unlock the panel.
•
[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the panel is locked.
Menu button
Click this button to execute the following functions.
•
[Copy]
Copies the Parameter Assign, Dimmer & Lock, and Source Select of the displayed DCP to the copy buffer.
•
[Paste]
Overwrites the Parameter Assign, Dimmer & Lock, and Source Select settings of the same model from the
copy buffer onto the displayed DCP.
It is only possible to paste settings that were copied within the same MTX system.
•
[Initialize]
Initializes the Parameter Assign, Dimmer & Lock, and Source Select settings of the displayed DCP.
•
[Clear [Parameter Assign]]
Initializes the Parameter Assign settings of the displayed DCP.
[Close] button
Closes the dialog box.
26. DCP
ProVisionaire Design User Guide | 341