User Manual

VXL1-16P Remote Control Protocol Specications Version 1.0.0 rev1
5
1. Setup
1.1. Connection Procedure
Remote Controller
Network
Switch
Ethernet
VXL1-16P
Ethernet Dante conector
1.2. Conguring the Remote Controller
VXL1-16P can be controlled from an external controller through the Ethernet (Dante) connector
The conguration on the remote controller side for each type of connection is shown below.
Ethernet (NETWORK connector) control
IP Address: Specify the IP address of the VXL1-16P
IP Port No.: 49280
1.3. Device Conguration
The setting required on the main unit is the IP address (UNIT ID) setting.
Up to four remote controller devices can connect simultaneously to one VXL1-16P device.