Service manual

2-12
STARTER (CHOKE) CABLE FREEPLAY ADJUSTMENT/
EXHAUST SYSTEM INSPECTION
INSP
ADJ
ESS00050
STARTER (CHOKE) CABLE FREEPLAY AD-
JUSTMENT
1. Pull back the starter cable outer tube
1
.
2. Measure:
S Starter cable freeplay
a
Out of specification  Adjust.
Starter cable freeplay
a
:
0.5  1.5 mm (0.02  0.06 in)
3. Adjust:
S Starter cable freeplay
Adjustment steps:
S Pull back the adjuster cover
1
.
S Loosen the locknut
2
.
S Turn the adjuster
3
in or out until the specified
freeplay is obtained.
Turning in  Freeplay is increased.
Turning out  Freeplay is decreased.
S Tighten the locknut and push in the adjuster
cover.
ESS00053
EXHAUST SYSTEM INSPECTION
1. Remove:
S Springs
Refer to “EXHAUST ASSEMBLY” in CHAP-
TER 5.
2. Inspect:
S Exhaust joint
1
S Exhaust pipe
2
S Exhaust silencer
3
Cracks/damgae  Replace.
S Exhaust gaskets
4
Exhaust gas leaks  Replace.
3. Check:
S Tightening torque
Bolt (exhaust pipe joint):
30 Nm (3.0 mSkg, 22 ftSlb)
4. Install:
S Springs
Refer to “EXHAUST ASSEMBLY” in CHAP-
TER 5.