Service manual

2-5
OIL PUMP
INSP
ADJ
NOTE:
10. Remove:
S Bleed bolt
1
S Gasket (bleed bolt)
11. Drain the oil until no more air bubbles ap-
pear from the bleed hole.
12. Inspect:
S Gasket
1
(bleed bolt)
Damage/wear  Replace.
13. Install:
S Gasket
1
(bleed bolt)
S Bleed bolt
2
14. Install:
S Carburetors
Refer to “CARBURETORS” in CHAPTER 6.
ESS00036
Cable adjustment
Before adjusting the oil pump cable, the throttle
cable distance should be adjusted.
Adjustment steps:
S Pull back the adjuster cover.
S Loosen the locknut
1
.
S Turn the adjuster
2
in or out until the specified
distance is obtained.
Oil pump cable adjusting length
a
:
24  26 mm (0.9  1.0 in)
Turning in  Length
a
is increased.
Turning out  Length
a
is decreased.
S Tighten the locknut
1
and push in the ad-
juster cover.