Service manual

5-30
RECOIL STARTER
ENG
NOTE:
7. Install:
Spring (drive plate)
Spring seat
Drive plate
Special washer
Washer
Spring washer
Nut
Be sure the cutout portion in the drive plate fits
over the post on the drive pawl.
Nut (drive plate):
10 Nm (1.0 mkg, 7.2 ftlb)
LOCTITE
8. Pull about four inches of starter rope from out
of the cutout portion in the sheave drum, and
rotate the sheave drum five times counter-
clockwise to preload the starter spring.
Then knot the rope end so that it will not be
pulled into the recoil starter case.
9. Install:
Recoil starter
Starter handle
Bolt (recoil starter):
10 Nm (1.0 mkg, 7.2 ftlb)
10. Check the starter for smooth operation. If it
does not operate smoothly, repair it.