Service manual
4-31
BRAKE
POWR
TR
INSTALLATION
1. Assemble:
Caliper body
Assemblage steps:
Lubricate the spiral gears
1
on the caliper
body and lever
2
with silicone grease.
Align the projection mark
1
on the lever with
the “86” mark
2
on the caliper body, screw the
lever
3
counterclockwise to the caliper body.
Install the stopper pin
1
into the holes on the
caliper body and stationary cover, then tighten
the bolts (stationary cover).
Bolt (stationary cover):
9 Nm (0.9 mkg, 6.5 ftlb)
Lubricate the one way locks 1
1
and 2
2
with
a lithium grease.
Lubricate the adjusting screw and back up
plate with a silicone grease.
Insert the back up plate
1
into the lever shaft
hole
2
.