Service manual

7-8
-+
ELEC
CHECKING THE CONDITION OF THE BULB
SOCKETS
The following procedure applies to all of the bulb
sockets.
1. Check:
8bulb socket (for continuity)
(with the pocket tester)
No continuity J Replace.
Pocket tester
90890-03132 (YU-03112-C)
NOTE:
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
*****************************************************
a. Install a good bulb into the bulb socket.
b. Connect the pocket tester probes to the re-
spective leads of the bulb socket.
c. Check the bulb socket for continuity. If any
of the readings indicate no continuity, re-
place the bulb socket.
*****************************************************
CHECKING THE BULBS AND BULB SOCKETS