Guide
TOOLS for n Version2 Update Guide
8
[6] Make the initial setup for the n series Driver and WDM Audio/MIDI Driver.
(Windows XP only)
The “Found New Hardware Wizard” windows appear when the update of the n8/n12 firmware has been completed. Complete each
of the Wizards by following the instructions after No.16 in the TOOLS for n Version2/Cubase AI Installation Guide (page 7).
NOTE
• If the installation wizard window appears, select the radio button next to “Install the software automatically [Recommended],” then click
[Next]. When the message of the installation completion is displayed, click [Finish].
• A dialog box may appear asking you whether you wish to connect to Windows Update. In this case, select the radio button to the left of “Not at
this time,” then click [Next].
• If you are using Windows Vista, the initial settings are automatically done.
[7] Confirm whether or not installation is completed successfully
For details, refer to the TOOLS for n Version2/Cubase AI Installation Guide.
[8] Update Sweet Spot Data Manager
For details, refer to the Installation Guide included in the Sweet Spot Data Manager.
Mac
[1] Install TOOLS for n Version2
[2] Turn on the power to the n8/n12
[3] Update IEEE1394 firmware
[4] Update n8/n12 firmware
[5] Confirm whether or not installation is completed successfully
[6] Update Sweet Spot Data Manager
[1] Install TOOLS for n Version2
For details, refer to the section “ [1] Install TOOLS for n Version2 ” (page4).
[2] Turn on the power to the n8/n12
[3] Update IEEE1394 firmware
For details, refer to the Update Guide included in the IEEE1394 Firmware Updater.
[4] Update n8/n12 firmware
For details, refer to the Update Guide included in the n8/n12 Firmware Updater.
[5] Confirm whether or not installation is completed successfully
For details, refer to the section “ [3] Confirm whether or not installation is completed successfully” (page4).