Owner's Manual

Chapter 6 Component Guide
DME Designer Owner’s Manual
444
Dist->Delay
One input, two
output distortion
and delay effects in
series.
DST.Type DST1, DST2, OVD1, OVD2,
CRUNCH
Distortion type (DST = distortion, OVD = overdrive)
Drive 0 to 100 Distortion drive
Master 0 to 100 Master volume
Tone -10 to +10 Tone control
N.Gate 0 to 20 Noise reduction
Delay 0.0 to 2725.0 ms Delay time
FB.Gain -99 to +99% Feedback gain (plus values for normal-phase
feedback, minus values for reverse-phase
feedback)
Hi.Ratio 0.1 to 1.0 High-frequency feedback ratio
Freq. 0.05 to 40.00 Hz Modulation speed
Depth 0 to 100% Modulation depth
Dly.Bal 0 to 100% Distortion and delay balance (0% = all distortion,
100% = all delayed distortion)
Multi.Filter
Two input, two
output 3-band
multi-filter (24 dB/
octave).
Type 1 HPF, LPF, BPF Filter 1 type: high pass, low pass, band pass
Type 2 HPF, LPF, BPF Filter 2 type: high pass, low pass, band pass
Type 3 HPF, LPF, BPF Filter 3 type: high pass, low pass, band pass
Freq. 1 28.0 Hz to 16.0 kHz Filter 1 frequency
Freq. 2 28.0 Hz to 16.0 kHz Filter 2 frequency
Freq. 3 28.0 Hz to 16.0 kHz Filter 3 frequency
Level 1 0 to 100 Filter 1 level
Level 2 0 to 100 Filter 2 level
Level 3 0 to 100 Filter 3 level
Reso. 1 0 to 20 Filter 1 resonance
Reso. 2 0 to 20 Filter 2 resonance
Reso. 3 0 to 20 Filter 3 resonance
Stereo Reverb
Two input, two
output stereo
reverb.
Rev Time 0.3 to 99.0 s Reverb time
Rev Type Hall, Room, Stage, Plate Reverb type
Ini.Dly 0.0 to 100.0 ms Initial delay before reverb begins
Hi.Ratio 0.1 to 1.0 High-frequency reverb time ratio
Lo.Ratio 0.1 to 2.4 Low-frequency reverb time ratio
Diff. 0 to 10 Reverb diffusion (left-right reverb spread)
Density 0 to 100% Reverb density
E/R Bal. 0 to 100% Balance of early reflections and reverb (0% = all
reverb, 100% = all early reflections)
HPF THRU, 21.2 Hz to 8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz to 16.0 kHz, THRU Low-pass filter cutoff frequency
Effect Type Parameter Setting Range Function