Owner's Manual

M7CL V2 Editor Owner’s Manual

G DYN1/DYN2 (Dynamics 1//Dynamics 2)

These buttons switch the two dynamics processors on/off. This is the same as the

dynamics 1/dynamics 2 for INPUT CH (➥ p.12).

H MIX/MATRIX SEND

Switches between the send indications to MIX buses 1–16 or to MATRIX buses 1–8.

This is the same as the mix/matrix send for INPUT CH (➥ p.12).

I BALANCE

The BALANCE knob adjusts the balance of the signal that is sent from the ST IN chan-

nel to the STEREO bus L/R channels (or the L/C/R channels). Other than the BAL-

ANCE knob, this is the same as PAN/TO STEREO MONO for an INPUT channel

(➥ p.13).

J SEL (Select)

Selects the ST IN channel for which you want to perform operations. (L and R can be

selected separately.) This is linked with the ST IN section [SEL] keys on the M7CL’s

panel.

K CUE

This button cue-monitors the signal of the ST IN channel (L/R are linked). This is

linked with the ST IN section [CUE] keys on the M7CL’s panel.

L ON

Switches the ST IN channel on/off (the L/R settings are linked). This is linked with the

ST IN section CH [ON] keys on the M7CL’s panel.

M Fader

Adjusts the input level of the ST IN channel. When the M7CL itself is in other than

SENDS ON FADER mode, this is linked with the INPUT section faders of the M7CL’s

panel.

The current fader value is shown in the numerical box located immediately below the

fader. This is the same as the fader for INPUT CH (➥ p.13).

N Channel number

This is the number of the ST IN channel. You can double-click this number to open the

Selected Channel window for this channel. If you hold down the <Ctrl> key of your

computer keyboard and double-click this, the Selected Channel window will open as an

additional view.

O Channel name

This is a text box that displays the channel name. You can also edit the channel name in

this text box.