Service manual

STEERING
5-50
4. Install:
• Under bracket 1
NOTE:
Apply the lithium soap base grease on the
bearing.
5. Install:
• Ring nut 1
T 1 Nm (0.1 mdkg, 0.7 ftdlb)
Tighten the ring nut using the ring nut
wrench 2.
Refer to “STEERING HEAD INSPECTION
AND ADJUSTMENT” section in the CHAP-
TER 3.
6. Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
8. Install:
• Front fork 1
• Steering damper stay 2 (right side only)
• Handlebar 3
• Handle crown 4
NOTE:
• Temporarily tighten the pinch bolts (under
bracket).
• Do not tighten the pinch bolts (handle crown,
steering damper stay and handlebar) yet.
CHAS
7. Install:
• Plain washer 1