Service manual
FRONT WHEEL AND REAR WHEEL
5-5
EC524100
Clutch hub
1. Inspect:
• Bearing 1
Rotate inner race with a finger.
Rough spot/Seizure ≥ Replace.
EC595000
ASSEMBLY AND INSTALLATION
EC515172
Front wheel
1. Install:
• Bearing (right) 1
• Spacer 2
• Bearing (left) 3
NOTE:
• Apply the lithium soap base grease on the
bearing when installing.
• Use a socket that matches the outside diam-
eter of the race of the bearing.
• Right side of bearing shall be installed first.
CC
CAUTION:
Do not strike the inner race of the bearing.
Contact should be made only with the
outer race.
CHAS
EC594300
Clucth hub clearance
1. Inspect:
• Clucth hub clearance a
Out of specification ≥ Adjust by adding
the supplyed shim [0.3 mm (0.012 in)].
Clucth hub clearance:
Zero~0.3 mm (Zero~0.012 in)
a
NOTE:
• When inspecting the clutch hub clearance,
measure it as it is assembled to the body at
specified torque.
• Measurement may be made of the clearance
either between the shim 1 and clutch hub 2
or between the shim and sprocket 3.