User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 1 Preparing for operation
Amp Editor Owner’s Manual
5
Parameters that can be monitored/controlled
: Available
— : Not available
* For more about the Signal Path View, refer to page144.
** Polarity switching for the TXn is performed in the Signal Path View.
Parameter TXn
ACD1
XMV
Tn/PC-N XP/XM/XH
Signal Path View* Component parameter editing ———
Analog Input
Level meter ——
Mute switching ———
Slot Input
Pre Input meter ———
Mute switching ———
Speaker Output
Level meter (output voltage)
Power meter ——
Impedance meter ——
Attenuation operations —
Attenuator’s Link switching ——
Mute switching
Solo switching —
Polarity (phase reversal) switching ** —
Slot Output Level meter ———
General
Power Standby/On operations
Temperature meter ——
Protection monitor
Amp Output mode detection —
Amp Output mode switching ———
Fan meter ———