Service manual
5-26
CHAS
REAR WHEEL AND REAR BRAKE
INSPECTION
EC514100
Wheel
1. Measure:
• Wheel runout
Out of limit → Repair/replace.
REMOVAL POINTS
EC523101
Rear wheel
1. Remove:
• Wheel 1
Push the wheel forward and remove the drive
chain 2.
EC513201
Wheel bearing (if necessary)
1. Remove:
• Bearing 1
Remove the bearing using a general bearing
puller2.
2. Inspect:
• Bearing
Rotate inner race with a finger.
Rough spot/seizure → Replace.
Replace the bearings, oil seal and wheel collar
(wheel sprocket side) as a set.
Wheel runout limit:
Radial 1: 2.0 mm (0.08 in)
Lateral 2: 2.0 mm (0.08 in)
EC514200
Wheel axle
1. Measure:
• Wheel axle bends
Out of specification → Replace.
Use the dial gauge 1.
Wheel axle bending limit:
0.5 mm (0.020 in)
TIP
TIP
TIP