Service manual

4-46
ENG
CLUTCH AND PRIMARY DRIVEN GEAR
7. Install:
• Pressure plate 1
• Clutch spring 2
• Bolt (clutch spring) 3
• Align the arrow mark a on the pressure plate
with the punched mark b on the clutch boss.
• Tighten the bolts in stage, using a crisscross
pattern.
5. Install:
• Ball
Apply the engine oil on the ball.
6. Install:
• Push rod 1 1
• Push plate 2
• Washer 3
• Nut (push rod 1) 4
8. Check:
• Push lever position
Push the push lever assembly in the arrow
direction and make sure that the mach mark
are aligned → adjust.
a Match mark on the push lever assembly
b Match mark on the crankcase
6 Nm (0.6 m • kg, 4.3 ft • lb)
TIP
TIP