User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Appendix
Amp Editor Owner’s Manual
212
Clock set Clock set —
The setting of the internal
clock has been changed.
—
Information
Single
— —
Amp
disconnected[**]
Disconnected
[**]
—
The amplifier identified as
AMP ID** is disconnected
from the ACD1.
Check the connection between
the [DATA PORT] connector on
the ACD1 and the amplifier.
Error Single
Amplifier information
—
Scene recalled
[**]
ScnRecalled[**] —
Scene number ** was
recalled.
—
Information
Single
——
Preset recalled
[**]
——
Preset number ** was
recalled.
—
Information
Single
— Scene stored[**] SceneStored[**] —
Scene number ** was
stored.
—
Information
Single
—— Preset stored[**] — —
Preset number ** was
stored.
—
Information
Single
Synchronizing Synchronizing —
Amp Editor and the
amplifier began
synchronizing.
—
Information
Single
Power amp
mode changed
AmpMode
changed
—
The Power Amp Mode was
changed.
—
Information
Single
—
Input
overridden[Ch*]
In overridden[*] —
The Redundant Override
function has been
engaged and the channel*
has been switched to
analog input.
—
Information
Continual
— —
Amp type
changed
Amp type
changed
—
A different model of the
amplifier has replaced the
connected amplifier and
has been reset to default.
—
Information
Single
TXn
ACD1
XMV
Message
(shown in
Amp Editor)
Message
(shown on
TXn/ACD1)
Alert number
(shown on
XMV)
Content Response Initial type
Single/
Continual