Service manual

3-42
CHK
ADJ
5. Install:
• headlight bulb
Secure the new headlight bulb with the
headlight bulb holder.
CAUTION:
Avoid touching the glass part of the
headlight bulb to keep it free from oil,
otherwise the transparency of the glass, the
life of the bulb, and the luminous flux will be
adversely affected. If the headlight bulb gets
soiled, thoroughly clean it with a cloth
moistened with alcohol or lacquer thinner.
6. Attach:
• headlight bulb holder
7. Connect:
• Headlight coupler
8. Install:
• Front cover
Refer to “FRONT COVER, INNER PANEL
AND FRONT INNER PANEL” section.
REPLACING THE REAR TURN SIGNAL LIGHT BULBS
EAS00183
REPLACING THE REAR TURN SIGNAL
LIGHT BULBS
The following procedure applies to both of the
turn signal light bulbs.
1. Remove:
• Turn signal light lens 
2. Remove:
• Turn signal bulb  (push and turn it
counterclockwise)
WARNING
Since the turn signal light bulb gets extremely
hot, keep flammable products and your hands
away from the bulb until it has cooled down.
3. Install:
• Turn signal light bulb
(push and turn
it clockwise until it stops)
CAUTION:
Avoid touching the glass part of the
headlight bulb to keep it free from oil,
otherwise the transparency of the glass, the
life of the bulb, and the luminous flux will be
adversely affected. If the headlight bulb gets
soiled, thoroughly clean it with a cloth
moistened with alcohol or lacquer thinner.

