Service manual

3-41
CHK
ADJ
3. Replace:
• blown fuse
왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔
a. Set the main switch to “OFF”.
b. Install a new fuse of the correct amperage.
c. Set on the switches to verify if the electrical
circuit is operational.
d. If the fuse immediately blows again, check
the electrical circuit.
왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖
Items Amperage Q’ty
Main fuse 20A 1
Fan fuse 7.5A 1
WARNING
Never use a fuse with an amperage rating
other than that specified. Improvising or
using a fuse with the wrong amperage rating
may cause extensive damage to the electrical
system, cause the lighting and ignition
systems to malfunction and could possibly
cause a fire.
4. Install:
• Battery cover
Refer to “SIDE COVERS AND SEAT” sec-
tion.
EAS00183
REPLACING THE HEADLIGHT BULBS AND
THE FRONT TURN SIGNAL LIGHT BULBS.
The following procedure applies to both of the
headlight bulbs.
1. Remove:
• Front cover
Refer to “FRONT COVER, INNER PANEL
AND FRONT INNER PANEL” section.
2. Disconnect:
• Healight coupler 
3. Detach:
• Headlight bulb holder 
4. Remove:
• Headlight bulb 
•Turn signal light bulbs 
WARNING
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
CHECKING THE FUSES / REPLACING THE HEADLIGHT
BULBS AND THE FRONT TURN SIGNAL LIGHT BULBS






