Service manual

ELEC
8-6
CHECKING THE CONDITION OF THE BULB
SOCKETS
The following procedure applies to all of the bulb
sockets.
1. Check:
bulb socket (for continuity)
(with the pocket tester)
No continuity → Replace.
Pocket tester
90890-03112
NOTE:
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔왔
a. Install a good bulb into the bulb socket.
b. Connect the pocket tester probes to the res-
pective leads of the bulb socket.
c. Check the bulb socket for continuity. If any of
the readings indicate no continuity, replace
the bulb socket.
왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖왖
CHECKING THE BULBS AND BULB SOCKETS