Service manual

CHAS
7-9
REAR WHEEL AND BRAKE
EAS00565
CHECKING THE REAR WHEEL
1. Check:
• wheel axle
• rear wheel
• wheel bearings
• oil seals
Refer to “FRONT WHEEL AND BRAKE DISC”
section.
2. Check:
• tyre
• rear wheel
Damage/wear → Replace.
Refer to “CHECKING THE TYRES” and
“CHECKING THE WHEELS” in chapter 3.
3. Measure:
• radial wheel runout 
• lateral wheel runout 
Refer to “FRONT WHEEL AND BRAKE DISC”
section.
Radial wheel runout limit
1.0 mm
Lateral wheel runout limit
0.5 mm
EAS00569
CHECKING THE REAR BRAKE
The following procedure applies to all of the
brake shoes.
1. Check:
• brake shoe lining
Glazed areas → Repair.
Sand the glazed areas with course sandpaper.
NOTE:
After sanding the glazed areas, clean the brake
shoe with a cloth.


346007
a
2. Measure:
• brake shoe lining thickness
a
Out of specification → Replace.
Brake shoe lining thickness limit
(minimum)
2 mm
WARNING
Do not allow oil or grease to contact the
brake shoes.