Service manual

SPEC

Bundle the coolant temperature sensor lead and

air induction system lead with the clamp. Cut the

clamp tip leaving 3 ~ 8 mm (0.12 ~ 0.31 in).

To the headlight.

Secure the wire harness to the holes at the inter-

nal left side and right side of the cover 2 with the

harness wrapping clamp.

Bundle the main switch lead, immobilizer lead,

left handlebar switch lead and right handlebar

switch lead with the clamp. Point the tip of the

clamp to the front side and set it between cover

and wire harness. Place the clamp at the right

side of the vehicle from the coupler as shown in

the illustration.

Fasten the cylinder identification sensor lead

and radiator fan motor lead to the frame with the

clamp as shown in the illustration. Point the tip of

the clamp to the downside.

Clamp it pointing the coolant reservoir tank hose

to the outside and the throttle body hose to the

inside. Position the clamp opening at the inside.

After binding a clamp, make sure to insert the

excessive part to the gap with the frame.

Clamp the coolant reservoir tank hose and brake

hose.

CABLE ROUTING