Service manual

ELEC
121
6. Turn the main switch on again.
Check that the ABS warning light goes on
for 2 seconds, then goes out for 3 seconds
and starts flashing.
7. Turn the main switch off.
8. Disconnect the test coupler adapter from
the test coupler, and install the protective
cap with the test coupler adapter. Deleting
the malfunction code is now finished.
N
O
TE:N
O
TE:
Do not forget to install the protective cap.
CAUTION:
Since the ECU remains in the memory until
the malfunction code is deleted, always
delete the malfunction code when the ser-
vice work is finished.
Main switch
ABS
waening light
2.0
se-
conds
ON
OFF
ON
Flashing
3.0
seconds
0.5
se-
conds
0.5
se-
conds
0.5
se-
conds
0.5
se-
conds
ANTI-LOCK BRAKE SYSTEM (ABS)