Owner`s manual

Trouble Recovery
97
EMU41460
Water separator-alert indicator blinks
while cruising
WARNING
EWM01500
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
● Do not perform this procedure on a hot
or running engine. Allow the engine to
cool.
● There will be fuel in the fuel filter. Keep
away from sparks, cigarettes, flames or
other sources of ignition.
● This procedure will allow some fuel to
spill. Catch fuel in a rag. Wipe up any
spilled fuel immediately.
● The fuel filter must be reassembled
carefully with the O-ring, filter cup, and
hoses in place. Improper assembly or
replacement could result in a fuel leak,
which could result in a fire or explosion
hazard.
If the water separator-alert indicator on the
Command Link tachometer blinks, perform
the following procedure.
F50, F60, T50, T60
1. Stop the engine.
2. Remove the top cowling.
3. Remove the plastic tie.
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
[ECM01950]
5. Unscrew the filter cup from the filter
housing. NOTICE: Be careful not to
twist the water detection switch lead
when unscrewing the filter cup.
[ECM01960]
1. Water separator-alert indicator
1. Plastic tie
1. Water detection switch coupler
1
ZMU05475
1
ZMU05476
6C1-9-19.book 97 ページ ２０１０年２月１７日 水曜日 午後１時３８分