User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Basic operation
Yamaha LAN Monitor for Mac User Guide
11
Basic operation
1. Start Yamaha LAN Monitor.
2. From the network adapter selection pull-down menu in the toolbar, select the network adapter
to which the network that you want to monitor is connected.
3. Click [Setup] in the menu bar [Basic Settings] to configure basic Yamaha LAN Monitor
settings.
Click [OK] to apply settings.
NOTE
For more details on [Basic Settings], refer to the [Basic Settings] section (page 14) under the “Menu bar” (page 13).
Network adapter selection pull-down menu