User Manual

Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON5 Disable - Access 1(default) - ✓
etherCON6 Disable - Access 1(default) - ✓
etherCON7 Disable - Access 2 - ✓
etherCON8 Disable - Access 2 - ✓
opticalCON9 Disable
sa1 Trunk 1(native), 2 ✓ -
opticalCON10 Disable
• SWP1-8/8MMF's VLAN preset A settings (VLAN interface)
• VLAN #1(for Dante)
•
IPv4 Address : DHCP
• IGMP Snooping : Enable
• Querier : Enable
• Query Interval : 30sec
• Fast-Leave : Disable
• Check TTL : Disable
• VLAN #2(for Control)
• IGMP Snooping : Disable
• SWP1-8/8MMF's VLAN preset B settings (LAN/SFP port)
Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON1 Disable - Access 1(default) - ✓
etherCON2 Disable - Access 1(default) - ✓
etherCON3 Disable - Access 2 - ✓
etherCON4 Disable - Access 2 - ✓
etherCON5 Disable - Access 1(default) - ✓
etherCON6 Disable - Access 2 - ✓
etherCON7 Disable
sa1 Trunk 1(native), 2 ✓ -
etherCON8 Disable
opticalCON9 Disable
sa2 Trunk 1(native), 2 ✓ -
opticalCON10 Disable
• SWP1-8/8MMF's VLAN preset B settings (VLAN interface)
• VLAN #1(for Dante)
•
IPv4 Address : DHCP
• IGMP Snooping : Enable
• Querier : Enable
• Query Interval : 30sec
• Fast-Leave : Disable
• Check TTL : Disable
• VLAN #2(for Control)
• IGMP Snooping : Disable
• SWP1-8/8MMF's VLAN preset C settings (LAN/SFP port)
Interface L2MS Filter LAG(Static) Port Mode VLAN STP
Loop
Detection
etherCON1 Disable - Access 1(default) - ✓
etherCON2 Disable - Access 1(default) - ✓
etherCON3 Enable - Access 2 - ✓
Command Reference | Configuration | 23