Active Servo Processing Subwoofer System Owner's Manual

ManualsBrandsYamaha ManualsSpeakerSW-3

English

1 POWER indicator

Lights in green when the POWER switch is turned ON,

and goes off when turned OFF.

* STANDBY mode:

If the AUTO POWER ON/OFF switch on the rear panel

is set to ON, this indicator lights in red when no signal

is input to this unit.

2 AUTO POWER ON/OFF switch

By setting this switch to the ON position, this unit’s

automatic power ON/OFF function operates as described

below. If you do not need this function, set to the OFF

position.

* Make sure to change the setting of this switch only when

the power of this unit is off.

Automatic power ON/OFF function

When you play a source, the power to this unit turns on

automatically by sensing audio signals input to this unit.

The power turns off automatically if the source being

played is stopped or the input signal is cut off for several

minutes.

* This function will operate responding to a certain level of

input signal. Increase the output level on the input

source if the automatic power ON function will not

operate, or decrease the level if the automatic power

OFF function will not operate.

* There may be a case that the power turns on

unexpectedly by sensing noise from other appliances. If

it occurs, set the AUTO POWER ON/OFF switch to the

OFF position.

This function is available only when the power of this

unit is on (by setting the POWER switch (

4) to “on”).

3 INPUT1 (FROM AMPLIFIER) terminals

Used to connect this unit with the speaker terminals of the

amplifier.

4 POWER switch

Turns the power of this unit ON and OFF whenever

pressed. When this switch is turned ON, the POWER

indicator above the POWER switch lights up.

5 HIGH CUT control

Adjusts the high frequency cut off point.

Frequencies higher than the frequency selected by this

control are all cut off (and not output).

* One graduation of this control represents 10 Hz.

6 VOLUME control

Adjusts the volume level.

7 INPUT2 terminals

Used to input line level signals from the amplifier.

8 OUTPUT (TO SPEAKERS) terminals

Can be used for connections with the main speakers.

These terminals send signals output from the amplifier to

the main speakers directly.

CONTROLS AND THEIR FUNCTIONS

INPUT1INPUT2

FROM AMPLIFIER

OUTPUT

TO SPEAKERS

ON OFF

AUTO

POWER

POWER HIGH CUT

STANDBY

RED

GREEN

VOLUME

I50 Hz

0I0

50 Hz

OFF